LLCC68

E220P-400T22S LoRa spread spectrum technology wireless transmission monitoring

[IC]:LLCC68

[Frequency]:410.125~493.125MHz

[Power]:22dBm

[Distance]:7km

[Size]:16*26mm

[Product weight]:2g±0.1g

[Introduction]:E220P-400T22S adopts the new generation of LoRa spread spectrum technology, a wireless serial port module (UART) designed based on LLCC68 RF chip solution, and a built-in LNA, active temperature compensated crystal oscillator and receiving limiter in the wireless module. Under ideal conditions, the communication distance can reach 7km (5.6km for E220-400T22S), with stronger anti-interference ability and longer receiving distance. It supports functions such as air wake-up, carrier monitoring, communication key, and sub-packet length setting, and can provide customized development services.

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco

ZZteco


Main parameterPerformanceRemarks
Distance for reference  (km)7Test condition:clear and open area, antenna gain: 5dBi,antenna height: 2.5m,air data rate: 2.4kbps
TX length  (Byte)200Can be configured via command as 32/64/128/200 bytes per packet to transmit
Buffer  (Byte)400-
ModulationLoRaNew generation LoRa modulation technology
Communication interfaceUARTTTL Level
PackageSMD-
Size(mm)16*26-
AntennaIPEX/stamp hole50 ohm impedance
Main parameterMin.Typ.Max.UnitRemarks
Operating voltage  3.355.5V≥5V ensures output power
Communication level  -3.3-VFor 5V TTL, it may be at risk of burning down
Operating temperature-40-+85Industrial design
Operating frequency  410.125-493.125MHzSupport ISM band
TX current  -110-mAInstant power consumption @22dBm
RX current  -10-mA5V
Sleep current  -3.5-μASoftware is shut down
Max Tx power  212223dBm-
Receiving sensitivity  -132-135-136dBmAir speed 2.4 KBPS
Air data rate2.42.462.5kbpsControlled via user’s programming


ZZteco


No.NameDirectionFeatures
1GND-Ground
2GND-Ground
3GND-Ground
4GND-Ground
5M0Input(weak pull-up)Work with M1 to decide 4 working modes of module (not suspended, if not used, could be grounded).
6M1Input(weak pull-up)Work with M0 to decide 4 working modes of module (not suspended, if not used, could be grounded).
7RXDInputTTL UART inputs, connects to external (MCU, PC) TXD output pin
8TXDOutputTTL UART outputs, connects to external RXD (MCU, PC) input pin.
9AUXOutputUsed to indicate the working status of the module;The user wakes up the external MCU and outputs low level during power-on self-check initialization; (can be left floating)
10VCC-Power supply: 2.3~ 5.5V DC
11GND-Ground
12NC-Empty Pin
13GND-Ground
14NC-Empty Pin
15NC-Empty Pin
16NC-Empty Pin
17NC-Empty Pin
18NC-Empty Pin
19GND
Ground
20GND
   Ground
21ANT-Antenna
22GND-Ground